Safety Recall On Certain S&W M&P Shield EZ Pistols

Smith & Wesson has issued a safety recall on certain M&P Shield EZ pistols manufactured between March 1, 2020 and October 31, 2020. They have found cracked hammers on two of these pistols which will let them potentially have multiple discharges. The hammers were manufactured by an outside supplier for Smith & Wesson.

Smith & Wesson has identified two M&P Shield EZ Pistols on which the hammers manufactured by our supplier were cracked.  In those firearms, the hammer failed to fully engage the sear, causing the round to fire, cycling the slide, and potentially resulting in multiple discharges without depressing the trigger.  This issue can occur in the following two scenarios:

1. With a loaded magazine in the firearm and the grip safety depressed, releasing the slide (by pulling it back, or releasing the slide stop), may ignite the round as the slide closes, without engaging the trigger.  The condition may occur, regardless of the manual thumb safety position if equipped.  This may also result in multiple discharges.
 

2. With a loaded magazine in the firearm, the grip safety depressed, manual safety in the fire position, slide closed, and a round in the chamber, pulling the trigger will cause the round to fire normally, however as the slide cycles, the next round may be ignited as it is chambered by the hammer failing to fully engage the sear, causing multiple discharges.

In all cases, the firearm will NOT fire unless the grip safety is depressed.  While this condition has been found only in two hammers, and our investigation suggests that these two incidents are very isolated, any unintended discharge of a firearm has the potential to cause injury.  Therefore, we have established this Safety Recall as a precautionary measure to ensure that all M&P Shield EZ Pistols in service meet our design specifications. 

Stop using your M&P® Shield™ EZ pistol until you determine whether it is included in this safety recall, and if so, until it has been inspected and repaired by Smith & Wesson, if necessary.

PRODUCT AFFECTED:

This notice applies ONLY to M&P® Shield™ EZ pistols (including Performance Center® models) manufactured between March 1, 2020 and October 31, 2020, and only to a small percentage of that population. It does NOT apply to all SHIELD™ pistols.  To determine whether your M&P Shield EZ Pistol is affected, check the label on the box to determine date of manufacture (see image below), and if manufacture date is between March 1, 2020 and October 31, 2020 – your pistol may be affected. In this case (or if you are unsure of your date of manufacture), simply go to MPShieldEZrecall.com and input your serial number, or call 888-871-7114 .

Smith & Wesson has set up a special website where you can check your serial number to see if it is one of the impacted pistols. This recall applies to both 9mm and .380 Shield EZ pistols

You can go to the website here.


3 thoughts on “Safety Recall On Certain S&W M&P Shield EZ Pistols”

Leave a Reply

Your email address will not be published. Required fields are marked *